최신SAP Certified Application Associate - SAP IBP for Supply Chain (2205) - C_IBP_2205무료샘플문제

A. This application job can be run for multiple time profiles at once.

B. A time profile has to be activated so that the application job can proceed.

C. The assigned Planning Area must be active.

D. In the Parameter Section of the application job, choose the Time Profile ID and Planning Area.

A. A forecast metric key figure, such FCSTMAPE

B. A unit of measure key figure, such as UOMCONVERSIONFACTOR

C. A currency conversion key figure, such as exchange rate

D. A special key figure marked as an aggregate key figure (aggregate constraint)

A. Configuration items should be bundled in the collections based on the SAP IBP project stream.

B. A planning area with its time profile must be bundled in one collection.

C. A planning area with the copy operators assigned must be bundled in one collection.

D. You should delete collections after they have been transported.

A. You must mark the realignment step as "shared" and assign the steps to users.

B. The number of steps in the realignment run is limited to 255.

C. The name of the realignment step should be no longer than 20 characters.

D. A realignment step can change master data, planning objects and key figures.

A. Promotion Sales Lift Elimination

B. Substitute Missing with Mean or Median in Sales History

C. Intermittency Detection and Correction in Sales History

D. Bias Detection and Correction in Sales History

A. Keep the number of fairshare segments small.

B. Increase the use of incremental lot size beyond the frozen horizon.

C. Avoid using telescopic time buckets.

D. Use non-overlapping networks by using subnetwork ID maintained at Location-Products to reduce the size of the problem.

E. Split into multiple planning areas to support weekly vs. daily planning needs.

A. Lot sizes are time-independent master data settings.

B. Lot sizes are applicable for production and transportation quantities.

C. Periodic lot size setting overrides the minimum lot size.

D. Lot sizes are applicable for production and handling quantities.

A. Used by end-users in planning views to help visualize cross-period calculations

B. Used when you have more than three inputs at different planning levels in one calculation

C. Used to break down a large calculation into manageable subcalculations

D. Used at any level of calculation level except the Request Level