최신Alcatel-Lucent Services Architecture - 4A0-104무료샘플문제

A. The VLAN tag is removed, and the frame is transported over the network.

B. The VLAN tag is kept, and the frame is transported over the network.

C. The frame is dropped.

D. The VLAN tag is kept, a VLAN of 0 is added, and the frame is transported over the network.

A. All of the above statements are true.

B. A VRF contains a single VPRN routes.

C. On the 7750 SR, by default, there is a unique one-to-one association between a VPN label and a VRF

D. Every VRF in a PE is associated with one or more route target attributes.

E. Each VPRN needs a separate VRF in each PE router.

F. All of the above statements are false.

A. 4

B. 5

C. 2

D. 6

E. 10

F. 3

A. Each router requires 6 SDPs.

B. Each router requires 2 SDPs.

C. Each router requires 1 SDP.

D. Each router requires 3 SDPs.

A. Enabling the port using the no shutdown command.

B. Ports are enabled by default, thus no need to use the no shutdown command.

C. Configuring the physical port in network mode.

D. Configuring the physical port in access mode.

A. Service providers only need to perform configurations on the PEs to add additional VPRNs.

B. For each VPRN, only one customer can be connected at each PE.

C. Customers must use the same routing protocol as the service provider.

D. Customers belonging to the same VPRN service must use the same subnet.

A. They are distributed to all PEs and CEs that are part of the VPRN.

B. They are used to identify the VRF table for a prefix at the receiving PE.

C. They are used by VPRNs to control the distribution of VPN routing information.

D. They are distributed to PEs to identify the VRF table that a VPN-IPv4 prefix is associated with.

A. NNI

B. Operational Control Word

C. VC Label

D. Tunnel Label

E. UNI

A. None. This encapsulation is not supported.

B. 4096

C. 1

D. The number is limited only by the capacity of the router

A. 10.10.10.1 has a different service MTU set.

B. The SDP to 10.10.10.1 on router R4 is shutdown.

C. 10.10.10.1 has not sent a label to router R4 yet.

D. Router R4 has not sent a label to router R1(10.10.10.1) yet.

A. 6VPE implements its own VPN-IPv6 address family and is a replacement for MP-BGP.

B. On a PE router, if the MP-BGP next hop is an IPv4 address, a mapped IPv6-compliant address will be used.

C. Customers connected to 6VPE can run IPv6 or IPv4.

D. 6VPE is a tunneling technology that makes use of MPLS tunnels to transport IPv6 prefixes over an IPv4 infrastructure.

A. Traffic is flooded to all SAPs, spoke SDPs, and mesh SDPs in the service

B. Traffic is flooded to all SAPs and mesh SDPs in the service.

C. The traffic is not flooded.

D. Traffic is flooded to all SAPs and spoke SDPs in the service.

E. Traffic is flooded to all SAPs in the service.

A. Shut down all SDPs associated with the service.

B. Shut down all SAPs associated with the service.

C. Shut down the service.

D. Delete all SAPs and SDPs associated with the service.

E. Shut down all physical ports that are bound to a SAP.

F. Delete the Customer ID.

A. TRUE

B. FALSE

A. No, a routing policy is not required on PE1, but an import policy is required on PE2.

B. No, a routing policy is not required. By default, the Alcatel-Lucent 7750 SR will advertise all VPRN routes between PE routers.

C. Yes, A routing policy is required in this case because BGP is used as the PE-CE routing protocol.

D. Yes, A routing policy is required to advertise routes between PE routers in a VPRN regardless of the CE-PE routing.

A. TRUE

B. FALSE