결제 후 1분 이내에 NS0-502 학습 자료를 이메일로 받아보실 수 있습니다. ExamPassdump의 Network Appliance NetApp Certified Implementation Engineer - SAN, 7-Mode 연습문제 106문항으로 지금 바로 학습을 시작하시기 바랍니다.

Network Appliance NS0-502 시험 개요:

Network Appliance NS0-502 시험 요강 주제:

Network Appliance NetApp Certified Implementation Engineer - SAN, 7-Mode 시험, 이것이 궁금합니다

최신 Network-Appliance NAC-NIE Certification NS0-502 무료샘플문제

문제 #1

A company has FC patch panels in their data center. They plan on using them to interconnect their storage controllers to the FC switches and the hosts using the storage. They have 62.5 micron cable between the patch panels. Which cable should you use on the NetApp storage controller's Target Ports to make this a supported configuration?

A. short wave SFPs, 50 micron FC cable
B. long wave SFPs, 50 micron FC cable
C. long wave SFPs, 62.5 micron FC cable
D. short wave SFPs, 62.5 micron FC cable

문제 #2

You are creating an acceptance test plan and the subject of performance is raised. How should you define what the minimum performance should be?

A. You should work with the customer to understand their performance expectations and determine the minimum performance they require for the application this system will support.
B. You should use the published maximum performance specifications for this system.
C. You should look up the test results for a similar system in previous performance testing and use those numbers.
D. You should use the published minimum performance specifications for this system.

문제 #3

A 100-GB thinly provisioned LUN is allocated to a Windows host. 100 GB of data is written into the LUN. The current capacity utilization on the disk array as well as the host is 100%. 50 GB of data is deleted from the LUN. Space reclaimer has NOT been run. What is the current capacity utilization on both the host and the disk array?

A. 100% on the host, 50% on the disk array
B. 50% on the host, 100% on the disk array
C. 100% on the host, 100% on the disk array
D. 50% on the host, 50% on the disk array

문제 #4

What is NetApp's recommended best practice for zone configuration?

A. All zones should contain a single target and all the initiators using that target.
B. Individual zones can get too complicated. It is better to simply configure one default zone with all devices contained in it.
C. All devices from the same vendor should be in one zone.
D. All zones should contain a single initiator and all the targets that initiator accesses.

문제 #5

You need to gather information from the host systems that will be attached to the NetApp storage system using either FC or iSCSI. This information includes operating system version, patch levels, open bus slots, and cards in bus slots. What other information must you gather from the host systems?

A. bus type (PCIe and/or PCI-x)and Ethernet ports (both used and free)
B. bus type (PCIe and/or PCI-x) and video adapters
C. bus type (PCIe and/or PCI-x) and Serial ports (both used and free)
D. memory in system and Ethernet ports (both used and free)

질문과 대답: