최신Fortinet NSE 6 - Secure Wireless LAN 6.4 - NSE6_FWF-6.4무료샘플문제

A. Indicates channels that cannot be used because of regulatory channel restrictions

B. Indicates channels that will be scanned by the Wireless Intrusion Detection System (WIDS)

C. Indicates channels that can be used only when Radio Resource Provisioning is enabled

D. Indicates channels that are subject to dynamic frequency selection (DFS) regulations

A. DARRP performs continuous spectrum analysis to detect sources of interference. It uses this information to allow the AP to select the optimum channel.

B. DARRP measurements can be scheduled to occur at specific times.

C. DARRP performs measurements of the number of BSSIDs and their signal strength (RSSI). The controller then uses this information to select the optimum channel for the AP.

D. DARRP requires that wireless intrusion detection (WIDS) be enabled to detect neighboring devices.

A. Using the current number of wireless clients connected to the SSID and the number of IPs available in the least busy VLAN

B. Using the current number of wireless clients connected to the SSID and the group the FortiAP is a member of

C. Using the current number of wireless clients connected to the SSID and the number of clients allocated to each of the VLANs

D. Using the current number of wireless clients connected to the SSID and the number of VLANs available in the pool

A. For both interfaces in the wtp-profile, configure set vaps to be "Authors"

B. Disable intra-vap-privacy for the Authors vap-wireless network

C. For both interfaces in the wtp-profile, configure vap-all to be manual

D. Increase the transmission power of the AP radio interfaces