한 번의 불합격은 재응시료와 시간 낭비로 이어집니다. ExamPassdump의 JN0-352 연습문제 213문항으로 Juniper Enterprise Routing and Switching, Specialist (JNCIS-ENT) 시험을 철저히 대비하시기 바랍니다.

Juniper JN0-352 시험 개요:

Juniper JN0-352 시험 요강 주제:

Juniper Enterprise Routing and Switching, Specialist (JNCIS-ENT) 시험, 이것이 궁금합니다

최신 JNCIS-ENT JN0-352 무료샘플문제

문제 #1

You have configured a GRE tunnel from your local router with tunnel source 10.0.0.1 to a remote router at destination 192.168.0.1. The tunnel is functioning until you commit set routing-options static route 0.0.0.0/0 next-hop gr-0/0/0. This configuration causes the tunnel to go down. Which statement is correct in this scenario?

A. The destination IP was being resolved using the default route, which now points to the tunnel itself.
B. A GRE interface cannot be used as a next hop for a static route.
C. A GRE interface must use the loopback as its source address to be used as a default route.
D. The tunnel destination must be resolved by a /32 host route.

문제 #2

An update to your organization's network security requirements document requires management traffic to be isolated in a non-default routing-instance. You want to implement this requirement on your Junos-based devices.
Which two commands enable this behavior? (Choose two.)

A. set system management--instance
B. set routing--instances mgmt_junos interface em1
C. set routing--instances mgmtjunoa interface ge-0/0/0.0
D. set routing--instances mgmt_junos

문제 #3

You are asked to create a default route that will be advertised to your internal OSPF neighbors.
You have three upstream connections to the Internet and you must ensure that when available, all traffic uses ISP1 as your primary connection and only uses ISP2 and ISP3 when ISP1 is not available. Which solution should you implement in this scenario?

A. Create a default aggregated route.
B. Create a default static route with each neighbor address as the next hop.
C. Create a default static route with ISP1's address as the next hop while specifying the addresses for ISP2 and ISP3 as qualified next hops with a preference value of six or higher.
D. Create a default generate route that includes an import policy to match BGP routes from ISP1 and assign a preference value of four or less.

문제 #4

Which statement is correct about the exhibit?

A. Only the interface routes from inet.0 will be imported into both first.inet.0 and second.inet.0.
B. All routes from inet.0 will be imported into first.inet.0 and second.inet.0.
C. Only the interface routes from first.inet.0 and second.inet.0 will be imported into inet.0.
D. All the routes from first.inet.0 and second.inet.0 will be imported into inet.0.

문제 #5

Which statement is correct about controlling the routes installed by a RIB group?

A. A firewall filter must be configured to install routes in the RIB groups.
B. An export policy is applied to the RIB group.
C. Only routes in the last table are installed.
D. An import policy is applied to the RIB group.

질문과 대답: