최신Huawei HCIA-Datacom V1.0 - H12-811_V1.0무료샘플문제
문제1
Which of the following packets is used by OSPF to describe its link state database (LSDB)?
Which of the following packets is used by OSPF to describe its link state database (LSDB)?
정답: C
문제2
(The IP addresses of VLANIF interfaces on the same switch must be different.)
(The IP addresses of VLANIF interfaces on the same switch must be different.)
정답: A
설명: (ExamPassdump 회원만 볼 수 있음)
문제3
A trunk interface and a hybrid interface process packets in the same way when receiving data frames.
A trunk interface and a hybrid interface process packets in the same way when receiving data frames.
정답: B
문제4
If the MAC address of an interface is 00E0-FCEF-0FEC, the corresponding EUI-64 address is ( ).
If the MAC address of an interface is 00E0-FCEF-0FEC, the corresponding EUI-64 address is ( ).
정답: C
설명: (ExamPassdump 회원만 볼 수 있음)
문제5
A network administrator wishes to implement VLAN 10 to isolate certain users. It is common, however, for these users to often change their physical location. Which of the following VLAN implementations should be used?
A network administrator wishes to implement VLAN 10 to isolate certain users. It is common, however, for these users to often change their physical location. Which of the following VLAN implementations should be used?
정답: D
문제6
Which of the following commands can switch a view from the system view to the user view?
Which of the following commands can switch a view from the system view to the user view?
정답: D
설명: (ExamPassdump 회원만 볼 수 있음)
문제7
Network Address and Port Translation (NAPT) allows multiple private IP addresses to be mapped to the same public IP address through different port numbers. Which of the following statements about port numbers in NAPT is true?
Network Address and Port Translation (NAPT) allows multiple private IP addresses to be mapped to the same public IP address through different port numbers. Which of the following statements about port numbers in NAPT is true?
정답: C
설명: (ExamPassdump 회원만 볼 수 있음)
문제8
To enable Router A to communicate with Loopback 0 on Router B on the network shown in the figure, which of the following commands needs to be run on Router A?
To enable Router A to communicate with Loopback 0 on Router B on the network shown in the figure, which of the following commands needs to be run on Router A?
정답: D
설명: (ExamPassdump 회원만 볼 수 있음)
문제9
(By default, in the SNMP protocol, which port number is used by the proxy process to send alarm messages to the NMS?)
(By default, in the SNMP protocol, which port number is used by the proxy process to send alarm messages to the NMS?)
정답: D
설명: (ExamPassdump 회원만 볼 수 있음)
문제10
What of the following statements is correct regarding Access Control List types and ranges?
What of the following statements is correct regarding Access Control List types and ranges?
정답: A
문제11
When forwarding a data packet, a router needs to change the destination IP address of the packet.
When forwarding a data packet, a router needs to change the destination IP address of the packet.
정답: B
설명: (ExamPassdump 회원만 볼 수 있음)
문제12
On the command line interface of Huawei AR routers, the role of the Save command is to save the current system time.
On the command line interface of Huawei AR routers, the role of the Save command is to save the current system time.
정답: B
문제13
The router that runs OSPF first enters the Full state and then synchronizes the LSDB.
The router that runs OSPF first enters the Full state and then synchronizes the LSDB.
정답: B
설명: (ExamPassdump 회원만 볼 수 있음)
문제14
As shown in the figure, assume that the MAC address table of SWA is as follows. Host A sends a data frame whose destination MAC address is MAC-B to SWA. Which of the following statements is true?
Answer Choices:
As shown in the figure, assume that the MAC address table of SWA is as follows. Host A sends a data frame whose destination MAC address is MAC-B to SWA. Which of the following statements is true?
Answer Choices:
정답: D
설명: (ExamPassdump 회원만 볼 수 있음)