최신H3C Constructing Small - and Medium - Sized Enterprise Network - GB0-191-ENU무료샘플문제
문제1
The customer's network connection looks like:
HostA------MSR-1------MSR-2--------MSR-3------HostB
The IP address configuration has been completed on all devices. To realize that HostA can access HostB, which of the following statements is correct regarding routing configuration? (multiple choice)
The customer's network connection looks like:
HostA------MSR-1------MSR-2--------MSR-3------HostB
The IP address configuration has been completed on all devices. To realize that HostA can access HostB, which of the following statements is correct regarding routing configuration? (multiple choice)
정답: A,B,C
문제2
Methods of VLAN division include ______. (Multiple choice question)
Methods of VLAN division include ______. (Multiple choice question)
정답: A,B,C,D
문제3
The functions implemented by the IPv6 Neighbor Discovery Protocol include _____. (Multiple choice)
The functions implemented by the IPv6 Neighbor Discovery Protocol include _____. (Multiple choice)
정답: A,C,D,E
문제4
When the source host pings the destination device, if the network works normally, the destination device will respond to the source host with an ICMP_____ packet after receiving the message.
When the source host pings the destination device, if the network works normally, the destination device will respond to the source host with an ICMP_____ packet after receiving the message.
정답: C
문제5
According to the different ways the switch processes VLAN data frames, the port types of H3C Ethernet switches are divided into ______. (Multiple choice)
According to the different ways the switch processes VLAN data frames, the port types of H3C Ethernet switches are divided into ______. (Multiple choice)
정답: B,C,E
문제6
Two MSR routers MSR-1 and MSR-2 are connected through the WAN and dynamically complete remote route learning through RIPv2.
After stable for 2 minutes, the RIP update message from MSR-2 is received on MSR-1, which contains the route with Cost of 14, then ______. (Multiple choice)
Two MSR routers MSR-1 and MSR-2 are connected through the WAN and dynamically complete remote route learning through RIPv2.
After stable for 2 minutes, the RIP update message from MSR-2 is received on MSR-1, which contains the route with Cost of 14, then ______. (Multiple choice)
정답: A,C
문제7
The TFTP protocol is a protocol based on ______.
The TFTP protocol is a protocol based on ______.
정답: C
문제8
In the LCP negotiation phase, what content will PPP negotiate? (multiple choice)
In the LCP negotiation phase, what content will PPP negotiate? (multiple choice)
정답: A,D
문제9
Which of the following statements about frame relay are correct?
Which of the following statements about frame relay are correct?
정답: C
문제10
The WAN link between the two routers MSR-1 and MSR-2 uses the PPP protocol, and RIP is configured on the two routers to advertise routing information to each other. At present, you can see the RIP routes advertised by MSR-2 on MSR-1, but you can't see any RIP routes in the routing table of MSR-2. The possible reason is ______. (Multiple choice)
The WAN link between the two routers MSR-1 and MSR-2 uses the PPP protocol, and RIP is configured on the two routers to advertise routing information to each other. At present, you can see the RIP routes advertised by MSR-2 on MSR-1, but you can't see any RIP routes in the routing table of MSR-2. The possible reason is ______. (Multiple choice)
정답: A,C,D
문제11
A network administrator configured on a router
RIP: rip 1
version 2
network 100.0.0.0
network 8.0.0.0
However, it is found that the RIP route of the opposite end cannot be learned. The administrator needs to enable RIP debugging information on the router. Which of the following configurations can be used to view RIP debugging information on the router?
A network administrator configured on a router
RIP: rip 1
version 2
network 100.0.0.0
network 8.0.0.0
However, it is found that the RIP route of the opposite end cannot be learned. The administrator needs to enable RIP debugging information on the router. Which of the following configurations can be used to view RIP debugging information on the router?
정답: D
문제12
The correct description of the startup process of the router system in the following options is ______.
The correct description of the startup process of the router system in the following options is ______.
정답: C
문제13
Which of the following descriptions about Frame Relay DLCI are correct? (multiple choice)
Which of the following descriptions about Frame Relay DLCI are correct? (multiple choice)
정답: B,D