최신Cisco Interconnecting Cisco Networking Devices Part 1 - 640-822무료샘플문제
문제1
You run the command debug ip rip on your router and notice this entry:
08:08:30:
RIP: build update entries
08:08:30:
network 192.168.10.0 metric 16
What is this information telling you?
You run the command debug ip rip on your router and notice this entry:
08:08:30:
RIP: build update entries
08:08:30:
network 192.168.10.0 metric 16
What is this information telling you?
정답: D
문제2
Refer to the exhibit.
A network technician is unable to ping from R1 to R2. What will help correct the problem?
Refer to the exhibit.
A network technician is unable to ping from R1 to R2. What will help correct the problem?
정답: E
문제3
Refer to the exhibit.
A network administrator has configured a Catalyst 2950 switch for remote management by pasting into the console the configuration commands that are shown in the exhibit. However, a Telnet session cannot be successfully established from a remote host. What should be done to fix this problem?
Refer to the exhibit.
A network administrator has configured a Catalyst 2950 switch for remote management by pasting into the console the configuration commands that are shown in the exhibit. However, a Telnet session cannot be successfully established from a remote host. What should be done to fix this problem?
정답: E
문제4
HOTSPOT
Click on the correct location or locations in the exhibit.
HOTSPOT
Click on the correct location or locations in the exhibit.
정답:
Explanation:
FastEthernet0/0 and Serial 0/1
User the "show ip interface brief" command Notice that Router1 does not have Ethernet 0 and Serial 0 interfaces. FastEthernet 0/1 and Serial 0/0 were configured with their IP addresses therefore only FastEthernet 0/0 and Serial0/1 have not had any configurations applied.
문제5
HOTSPOT
Click on the correct location or locations in the exhibit.
HOTSPOT
Click on the correct location or locations in the exhibit.
정답:
Explanation:
512 Kbit/sec Use the "show interfaces serial 0/0" command
문제6
What is the subnet address for the IP address 172.19.20.23/28?
What is the subnet address for the IP address 172.19.20.23/28?
정답: D
문제7
From which IP address class can 15 bits be borrowed to create subnets?
From which IP address class can 15 bits be borrowed to create subnets?
정답: A
문제8
DRAG DROP
DRAG DROP
정답:
문제9
Refer to the exhibit.
A small company with two locations has just connected the locations together with routers and a serial connection. The routers are using RIP to learn the network topology. RouterB has learned a network from RouterA, but router RouterA is not learning from RouterB. Using the output shown, what is the most likely problem?
Refer to the exhibit.
A small company with two locations has just connected the locations together with routers and a serial connection. The routers are using RIP to learn the network topology. RouterB has learned a network from RouterA, but router RouterA is not learning from RouterB. Using the output shown, what is the most likely problem?
정답: A
문제10
HOTSPOT
Click on the correct location or locations in the exhibit.
HOTSPOT
Click on the correct location or locations in the exhibit.
정답:
Explanation:
The mask address of interface Fa0/1 of Router1 is /28, which has four 0 bits (1111 1111.1111 1111.1111 1111.11110000). Therefore there are 24- 2 = 14 assignable IP addresses for hosts on the LAN.
문제11
Which of the following are characteristics of a Frame Relay point-to-point subinterface? (Choose two.)
Which of the following are characteristics of a Frame Relay point-to-point subinterface? (Choose two.)
정답: B,C
문제12
Refer to the topology below.
What interfaces on Router1 have not had any configurations applied? (Choose two)
Refer to the topology below.
What interfaces on Router1 have not had any configurations applied? (Choose two)
정답: B,C
설명: (ExamPassdump 회원만 볼 수 있음)
문제13
HOTSPOT
Click on the correct location or locations in the exhibit.
HOTSPOT
Click on the correct location or locations in the exhibit.
정답:
Explanation:
Router1(conf)# interface s0/0 Router1(conf-if)# no shutdown
User the "show ip interface brief" command
From the output, we learn that the status of Serial0/0 interface which connects to ISP router is currently "administratively down". This status indicates this interface is shutting down so we need to turn it on.
문제14
Some of routers have been configured with default routes. What are some of the advantages of using default routes? (Choose two)
Some of routers have been configured with default routes. What are some of the advantages of using default routes? (Choose two)
정답: C,E
문제15
Host A needs to communicate with the email server shown in the graphic. What address will be placed in the destination address field of the frame when it leaves Host A?
Host A needs to communicate with the email server shown in the graphic. What address will be placed in the destination address field of the frame when it leaves Host A?
정답: B