An architect is designing a VMware Cloud Foundation (VCF) Fleet with multiple workload domains. To reduce hardware costs, an IT executive proposes deploying Fleet Management services and other core management components within one of the shared workload domains and eliminating a dedicated management domain.
Which design principle is recommended for deploying VCF?

• A. Consolidate management by relocating it into one of the shared workload domains.
• B. Use a separate vCenter outside of VCF for lifecycle services.
• C. Remove the management domain after the initial installation.
• D. Consolidate the workload domain by relocating into the management domain.

An enterprise architect is designing the physical networking architecture for a greenfield VMware Cloud Foundation (VCF) deployment in a single data center. The deployment includes a management domain and multiple workload domains, utilizing NSX for software-defined networking with Geneve overlay encapsulation. NSX Edge nodes will handle North/South routing and services.
Requirements:
* Scalable, non-blocking fabric with predictable oversubscription and low latency.
* Support for high-throughput traffic including vSAN, vMotion, and NSX overlay.
* End-to-end jumbo frame support for efficiency.
* No dependency on physical multicast routing or snooping for overlay (BUM) Broadcast, Unknown- unicast, and Multicast replication.
* Redundant connectivity from hosts to the fabric.
Constraints:
* Existing Top-of-rack switches are limited to 25 GbE host-facing ports.
* The physical network does not support multicast.
* Future expansion to multiple racks and higher port speeds (25/100 GbE) is anticipated.
What are the four design decisions that fit the architecture ' s physical design? (Choose four.)

• A. Configure head-end replication mode for BUM traffic in the NSX overlay transport zone to eliminate multicast dependency.
• B. Each ESX host with at least two 10 GbE physical NICs, connected redundantly to separate leaf (ToR) switches.
• C. Enable jumbo frames MTU 9190 end-to-end across all switch ports, inter-switch links, and VLAN Layer 3 interfaces used for host transport traffic.
• D. Deploy a leaf-spine topology with Layer 3 routing BGP between leaf and spine layers for scalable ECMP routing.
• E. Use multicast replication mode in the NSX overlay transport zone to leverage physical network multicast for BUM traffic.
• F. Implement Layer 2 extended across aggregation switches for VLAN spanning.
• G. Each ESX host has at least two 25 GbE physical NICs, connected redundantly to separate leaf (ToR) switches.

A regulated enterprise must ensure complete recoverability of VMware Cloud Foundation (VCF) management components based on the following scenarios:
* Post Upgrade Failures.
* VCF instance total loss.
* Workload Domain components loss.
The following conditions must be met:
* Snapshots are restricted.
* Backups must survive regional failures.
Which three design decisions directly address the design trait of recoverability? (Choose three.)

• A. Store the SDDC Manager, vCenter, NSX Manager and VCF Automation backups in an external replicated object store accessible from multiple failure domains.
• B. Maintain cold-standby clones of NSX Manager appliances for rapid redeployment.
• C. Depend on vSphere HA for management Virtual Machine (VM) recovery across clusters.
• D. Use isolated backup repositories for each management component to guarantee version pinning.
• E. Use VCF-native prechecks and postchecks to validate rollback-supporting upgrade paths.
• F. Replicate VCF Operations and VCF Operations for Networks image-based backups offsite.

An architect is designing a VMware Cloud Foundation (VCF) single sign-on solution with the following requirements:
* The provider should be able to handle failure of a single node.
* Some VCF components will not be able to access the management domain vCenter.
* The solution should be deployed using the fewest nodes possible, while still addressing all other requirements.
Which deployment mode for the single sign-on provider should be used?

• A. VCF LDAP Services (Embedded Mode)
• B. VCF LDAP Services (Appliance Mode)
• C. VCF Identity Broker (Embedded Mode)
• D. VCF Identity Broker (Appliance Mode)

The following information has been collected from an architect during initial VMware Cloud Foundation (VCF) design discussions:
* Applications must be designed to tolerate the failure of a single data center.
* Service account passwords must be stored and retrieved from the company password vault.
* The self service catalog must meet the Service Level Objective (SLO) of 75% successful requests measured over a 12 month period.
* Management plane applications must return to operation (RTO) in under 10 minutes.
* Third-party pen testing must be executed against the solution yearly with a pass rate of 80 percent or higher.
* The solution must provide the ability for users to view and track the progress of their requests.
* All Identity management must use an external SAML based identity provider.
Which four statements are Functional Requirements? (Choose four.)

• A. All Identity management must use an external SAML based identity provider.
• B. Management plane applications must return to operation (RTO) in under 10 minutes.
• C. The solution must provide the ability for users to view and track the progress of their requests.
• D. Service account passwords must be stored and retrieved from the company password vault.
• E. Applications must be designed to tolerate the failure of a single datacenter.
• F. Third-party pen testing must be executed against the solution yearly with a pass rate of 80 percent or higher.
• G. The self service catalog must meet the Service Level Objective (SLO) of 75% successful requests measured over a 12 month period.