최신Oracle Communications Session Border Controller 7 Basic Implementation Essentials - 1z1-404무료샘플문제

A. The deletion is lost on immediate reboot.

B. The deletion takes effect immediately in the saved configuration.

C. The deletion is reflected when viewing the running configuration.

D. The deletion always requires a reboot to take effect.

E. The deletion requires auto-save enabled.

A. group-policy andload-policy

B. proxy and proxy-pool

C. local-policy and session-group

D. session-router and router-group

E. realm-config and enum-group

A. HSRP

B. Proxy ARP

C. Reverse ARP

D. BOOTP

E. Gratuitous ARP

A. The training1 peer is the standby node.

B. The switchover berpd force commandwas executed to do a manual failover.

C. The training6 peer is the active node.

D. The training6 peer will wait 1050 ms before considering the training1 peer out of service.

E. The two nodes have different health scores.

A. they provide routing functions for IP, TCP, and SMTPusing application parameters

B. they are based on the Windows operating system

C. they are session-aware devices that enable control of end-to-end interactive communications across IP network borders

D. they provide signaling proxy functions for SIP, H.323, and MGCP, which includes access control, signaling constraints, and topology hiding

E. they replace typical edge routers and firewalls in order to provide a unified network border forsignaling and media control

A. Standby only

B. Secondary only

C. Standby orActive

D. Active node that no longer has a heartbeat

E. Active only

A. Navigate to the network-interface configuration element and configure the in- manipulationid parameter.

B. Navigate to the session-group configuration element and configure the in-manipulationid parameter.

C. Navigate to the session-agent configuration element and configure the in-manipulationid parameter.

D. Navigate to the sip-interface configuration element and configure the in-manipulationid parameter.

E. Navigate to the session-agent configuration element and configure the in-manipulationid parameter.