최신Oracle Communications Session Border Controller Implementation Essentials - 1z1-400무료샘플문제

A. Rear craft interface display

B. CMIP fault/response messages

C. Via the show system-alarms ACLI command

D. SNMP traps

E. The Acme Packet Net-Net 4000 Element Management System (EMS)

A. Multiple virtual gateways or gatekeepers can exist on a single Net-Net 4500.

B. Only a single virtual gateway can exist on a single Net-Net 4500.

C. The Net-Net 4500 can be configured to allow interworking between H.323 and MGCP.

D. The Net-Net 4500 can set the H.323 versions 1 through 6 on egress messages.

E. There is a feature that allows an H.323 terminal that is unable to support Fast Start to receive a Slow Start call from a Fast Start source through the Net-Net 4500.

A. Set link-redundancy to enabled in the system-config.

B. Set link-redundancy-state to enabled in the network-interface.

C. Set link-redundancy to enabled in the network-interface.

D. Run the superuser command enable phy-redundancy.

E. Set link-redundancy-state to enabled in the system-config.

A. Acme Control Protocol (ACP)

B. Acme Packet Session Descriptor (APSD)

C. Content Addressable Memory Daemon (CAMD)

D. Session Initiation Protocol Daemon (SIPD)

E. Middle box Control Daemon (MBCD)

A. nat-traversal

B. registration-interval

C. nat-mode

D. min-reg-expire

E. nat-interval

A. The local-address of an h323-stack does not need to be defined in the corresponding network-interface object.

B. An IP address to enable telnet to a network-interface must be defined appropriately in the corresponding network-interface object.

C. The local-address of an MGCP gateway IP does not need to be defined in the corresponding network-interface object.

D. IP addresses defined in steering pools do not need to be defined as part of the network-interface configuration object.

E. Every IP address referenced in a SIP configuration object must be defined as an IP
address in the corresponding network-interface object

A. SNB is the simplest model to troubleshoot.

B. PBRB-HMR is much easier to configure, even though it has similar performance to the SNB model.

C. PBRB-HMR is recommended for both peering and access architectures.

D. PBRB-HMR has lower performance overhead than SIP-NAT Bridge.

E. PBRB-HMR provides better topology hiding, at the expense of performance.

A. The User and Superusermodes are password protected.

B. You do not need User and Superuser mode passwords when accessing the ACLI using SSH.

C. The default user mode password is "acme".

D. Passwords are stored in NVRAM.

E. Passwords cannot be seen in the output from the running configuration.