최신Oracle SPARC M6-32 and SPARC M5-32 Servers Installation Essentials - 1z0-489무료샘플문제

A. Installation Guide

B. System Administration Guide

C. Installation and Configuration Plan

D. Server Product Notes

A. SP1 IP address

B. domain IP address

C. clock board IP address

D. Active SP IP address

E. SP0 IP address

A. The Power On/Standby button is located only on the front panel, not on the rear panel.

B. The System Key switch is located only on the front panel, not on the rear panel.

C. All the control keys mo on the front control panel, and all the LED signals are on the rear status panel.

D. The front control panel and rear status panel are hot-swappable.

E. An antistatic wrist strap connector can be found on both the front and rear panels.

A. Under ZFS, the boot devices/disks are placed in a ZFS poof (called rpool by default), and all datasets (consisting of file systems and volumes) are allocated flexibly from that pool.

B. For ZFS-based root file systems, EIS recommends you do not use H/W RAID 1 unless sufficient disks are available for ZFS to mirror itself.

C. For UFS-based root file systems, EIS recommends that H/W RAID 0 be used to mirror the bootdisk wherever it is available.

D. For ZFS-based root file systems, EIS recommends you do not use H/W RAID 0 unless sufficientdisks are available for ZFS to mirror itself.

A. Only 3x power cords need to be connected when operating the server at half load.

B. All six power cords must be connected, even if you are using only a single power grid.

C. The server is designed to be powered by two utility power grids.

D. With dual-power feed set up, the first set of three power cords connected to the server are usedto supply power, and the second set of three power cords are in standby mode.

E. You must connect three power cords (ACO, AC1, and AC2) to one power grid, and connect the remaining three power cords to a second power grid (AC3, AC4, and AC5).

A. show status /Servers/PDomains /PDomain_2/H0ST

B. show /Servers/PDomains /PDomain 2/HOST status detail

C. show /Servers/PDomains/PDomain^l/HOST status

D. show /Servers/PDomains/PDoraain_2/HOST status

A. You do not have the host control role enabled.

B. You have exceeded the maximum number of 30 user accounts.

C. You do not have the user management role enabled.

D. You need to add SSH keys to the system before creating additional user accounts.

A. CMU with full populated with DIMM

B. CMU with 1/4 populated with DIMM Q

C. CMU with 1/8 populated with DIMM

D. CMU with 1/2 populated with DIMM

E. CMU with no memory/DIMM populated